(Pencil Pleat, Pinch Pleat & Eyelet)
1. CHOOSE SINGLE OR PAIR?
SINGLE PANEL (Left or Right)
PAIR (Two Equal Curtains)
2. FIND WIDTH
Measure the curtain track or poles width, not the window.
If you are fitting a new track or poles this should extend 15cm to 50cm either side of the window (or on one side when single curtain in use).
This will allow the curtains to be stacked on the side of the window ***
Track With Overlap
3. FIND DROP
The length of your curtains depends on your preference.
Typical length measurements as follows.
A: Full length, which is approximately 1 to 1.5cm above the floor level.
B: Above the radiator, typically 2 to 5cm above the radiator.
C: Below the windowsill, typically around 15cm.
Eyelet curtains you should take your measurements from the very top of the curtain pole.
Pencil, Double Pinch
Measure from the top of the track or bottom of the curtain rings to the desired length of your curtains.
Pole With Rings Measurement
*** Check that your recess is deep enough to fit the curtains in to, also bearing in mind any obstructions such as handles.
Curtains Type (Depth Required)
Wave Curtains (75mm)
Pinch Curtains (50mm)
Eyelet Curtains (75mm)
Penci l Pleat Curtains(50mm)
Once you have entered your curtain pole or track width, we will calculate the amount of fabric required for your curtains. Some headings require more fullness or gathering than others so these headings will require more fabric, which is reflected in the price of the curtains. All curtains are made in increments of 1/2 widths:
Pencil Pleat 200%
Pinch Pleat 200%
Wave 150% or 200%
* You will need an eyelet larger than your pole diameter, to ensure that the eyelets can move freely along your pole